Gypsogem : Eco UV Seal + Sponge (for Waterproofing with glossy finish) [1 litre]

How to Use Eco UV Seal – Waterproof & UV Care for Gypsogem Eco Resin

Make sure your Gypsogem Eco Resin piece is fully cured before sealing. Follow these steps for a smooth, water-resistant finish:

1. Prepare the Surface
   • Ensure your resin creation is completely dry and free of dust.
2. Dampen the Sponge
   • Dip a 5 to 6cm size sponge into clean water and squeeze out the excess.
   • Lightly wipe down your resin piece to prep the surface.
3. Apply Eco UV Seal
   • Dip the damp sponge into the Eco UV Seal, squeeze again to remove excess.
   • Quickly and gently rub a thin, even layer over the surface.
   • Avoid letting the sealant pool or dry mid-application—less is more for an even finish.
4. Layer as Desired
   • Let the first layer dry fully before continuing.
   • If your gypsum creation has a base, apply Eco UV Seal in sections. You won’t be able to rest the sealed surface on a raw, unsealed area until it’s fully dry—so work in stages to ensure a smooth, even finish
   • The initial coat may appear more matte—gloss increases with each additional layer.
   • Repeat the process until you achieve your desired finish

Note: Applying Eco UV Seal with a dry brush or sponge may cause streaks, similar to traditional varnishes. The damp sponge method helps ensure a smooth, consistent result.

Storage Tips:

• Store in a cool, dry place away from direct sunlight.
• Always close the cap tightly after use to preserve freshness.